Led Indicator (Red) - Greenlee GATOR Operación Manual

Troubleshooting (cont'd)
If certain problems arise with the tool, an error code
appears on the LCD screen (see pg. 14).
Error
Meaning
Code
1 Overcurrent fuse
2 Overcurrent comparator
3 Overheated circuit board
4 Overheated battery
Battery empty; operation
5
stops
Faulty crimp; complete
6
cycle
Faulty crimp; incomplete
7
cycle
8 Low battery
9 Battery empty
Real-time clock battery
10
low
11 Tool deactivated
12 Service necessary
Real-time clock not
13
found
14 Bluetooth unit not found
®
15 [Not Used]
Pressure sensor not
16
found
17 Burst pressure exceeded
Battery temperature too
18
low
Blinking Screen 4,750
19
cycles exceeded
Greenlee Tools, Inc.
Gator Insulated Battery-Powered In-Line Crimper
®
Action
Seek Service
Seek Service
Cool Tool
Cool Battery
Charge Battery
Seek Service
Seek Service
Charge Battery
Charge Battery
Seek Service
Seek Service
Seek Service
1. Re-insert Battery
2. Seek Service
1. Re-insert Battery
2. Seek Service
Seek Service
Seek Service
Warm Battery
Seek Service
17

LED Indicator (red)

This tool is equipped with a special circuit board
incorporating several important features to inform
the user about the current status of the unit. The LED
signals in the following cases:
What happens Signal
Tool will not start,
and constant light for
20 seconds when trigger
is released
Tool will stop, and
constant light for
20 seconds after trigger
is released
Tool will stop, and
flashing light for
20 seconds when
trigger is released
and
Flashing light for 20
seconds at end of cycle
audible
warning
Note: The tool will indicate when re-certification is near.
Starting at 4,750 cycles or 21 months (whichever occurs
first), the red LED and work LED will flash, an audible
warning will sound, and the LED will display SERVICE
NECESSARY for 20 seconds after every cyce. After
5,000 cycles or 2 years, the tool will not operate unless
the battery is removed and reinstalled. Only one cycle is
possible each time the battery is reinstalled.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
What to
What it means
do
Change
Battery
or charge
charge low
battery
Motor current
exceeds 20 A
Let tool
during cycle
cool
Circuit has
become too hot
Indicates 4,750
Send tool
cycles exceeded
in for
or 21 months
service
exceeded