Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN SV500 Manual De Instrucciones

16.3 Unpacking

Carefully remove the packaging material and unit from the carton.

16.4 Disposal of the packaging

Caso believes in the importance of recycling and has selected packaging
materials that not only protect your unit from damage during transit, but can be recycled to
minimize any ecological impact. Recycling the packaging materials preserves raw
materials and reduces waste. Take any packaging materials that are no longer required to
a recycling collection point for proper disposal.
► If possible, keep the original packaging for the duration of the guarantee period in the
event a return is necessary.

17 Setup

17.1 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfill the following prerequisites:
 The device must be set up on a firm, flat, level and heat-resistant surface. The carrying
capacity of the support must be appropriate to withstand the weight of the device
including water filling and the heaviest expected food loading.
 Do not set up the unit in a hot or damp environment or near flammable material.
 Do not move the SV500 when it is in operation.
 The electrical outlet must be easily accessible so that the plug can be quickly
disconnected in the case of an emergency.
 The setup of this unit in non-stationary locations (e.g., boats, airplanes, motor homes)
must be carried out by a qualified electrician, provided they guarantee the prerequisites
for the safe use of the unit.

17.2 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before plugging in the unit, compare the voltage and frequency data on the vacuum
sealer's rating plate (found on the bottom of the unit) with that of your electrical
network. This data must be compatible. If in doubt consult a qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The use of a multi-plug outlet adapter is not recommended due to fire danger.
 Inspect the power cord for damage and ensure it doesn't run under the unit or over hot
or sharp surfaces.
PLEASE NOTE
30