Paoli DP 6000 CLASSIC HANDLE Manual De Instrucciones página 8

MAINTENANCE INSTRUCTIONS
Before any maintenance, always make
sure that the air supply of the wheel gun
is depressurized (no air pressure), and
only after unplugging the wheel gun and
performing maintenance.
L Use only recommended lubricants.
L Every 20-30 cycles it is recommended to
fill (special oil for Paoli air impact wrench
motors or very fluid oil for air tools) the
oil tank, by loosening (use a 10 mm Allen
key) the oil plug in the bottom side of
the wheel gun; then tighten again this
oil plug (view figure
capacity is ~ 7 cc. These operations alow
to keep the appliance efficient and to
extend its service life.
L Ship the wheel gun back to the PAOLI
facilities at least once per year for the
complete overhauling.
L Do not carry out maintenance with
improper tools, make use of the attached
exploded drawing with the list of spare
parts.
L Indicate the parts most subject to wear,
to be dismantled and checked at regular
intervals, as well as a list of malfunctions,
if any, and the corrective action.
SCRAPPING
Separate the components on the basis of the nature of the materials of which they are made. The
components must be disposed of according to the laws in force.
ENGLISH
8
OPERATING AND MAINTENANCE MANUAL
Fig.2-A). The oil tank
L Use only genuine spare parts and
authorized service organizations.
L Before every
recommended to clean the motor by
introducing diesel oil (~10cc) through
the air inlet, while keeping the trigger
pressed; then running the wheel gun
clockwise and anticlockwise (please pay
attention to the exhaust coming out from
the top of the wheel gun during this
operation - view figure
the inside washing, repeat the previous
operation with special oil for Paoli air
impact wrench motors (~5cc) or very
fluid oil for air tools
These operations must be performed in a
suitably equipped working environment,
complete with extraction equipment
for nebulised particles. Use personal
protective equipment.
L If the wheel gun is left unused for long
periods we recommend putting some
oil (special oil for Paoli air impact wrench
motors) into the air inlet
Fig.2-A) and letting it run for a few
seconds before putting it away. In this
way the internal components will remain
lubricated.
race it is strongly
Fig.2-B). After
(view figure Fig.2-A).
(view figure