Fastening The Grill And The Fan Blades - Domo DO8140 Manual De Instrucciones

www.domo-elektro.be
PARTS
1. Front grill
2. Spinner
3. Fan blades
4. Plastic screw
5. Rear grill
6. Screw for fastening rear grill
7. Motor drive
8. Oscillation button
9. Motor
10. Control Panel
11. Small screw
12. Clamp
13. Telescopic tube
14. Base mount
15. Base
16. Attaching clip
FASTENING THE BASE AND THE MOTOR
Loosen the butterfly screw and pinion at the bottom of the telescopic tube. Position the
telescopic tube in the base mount and fasten the tube with the pinion and the butterfly
screw. (Fig. 1)
Position the four parts of the base in the base mount. Make sure that the parts are
inserted properly. (Fig. 2)
Loosen the clamp and extend the top part of the tube completely and block the tube at
this height by tightening the clamp again (Fig. 3 - 4)
Make sure that the clamp is tightened before mounting the motor. Loosen the small
screw at the back of the control panel. Place the motor on the telescopic tube. Tighten
the small screw again, making sure that the screw is aligned with the recess in the
telescopic tube. The small screw must be fully tightened prior to using the fan. (Fig. 5)

FASTENING THE GRILL AND THE FAN BLADES

Remove the spinner from the motor drive (or remove it from the packaging). Loosen
the plastic screw from the motor drive. Position the grill behind the motor drive and
use the plastic screw to fasten the grill. (Fig. 1)
Place the fan blades on the motor drive. Make sure the pin on the motor drive fits
1
31
4
7
6
3
8
2
5
16
10
11
2 13
12
13
14
15
11
13
DO8140
9