Briggs & Stratton Elite Series Instrucciones De Uso página 6

Assembly
Section
3
ASSEMBLY
IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
Remove Pressure Washer From
Carton
1. Remove the parts bag, accessories, and inserts included
with pressure washer.
2. Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
3. Remove pressure washer from carton.
Carton Contents
Items in the carton include:
• Main Unit
• Safety Goggles
• Handle with Chemical Reservoir Assembly
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• Plastic Accessory Tray
• Oil Bottle
• Parts Bag (which includes the following):
• Owner's Manual
• Engine Manual
• Owner's Registration Card
• Bag containing 4 multi–colored ProjectPro™ Nozzles
• Maintenance Kit
• Handle/Tray Fastening Hardware Kit (which
includes):
• Carriage Bolts (2)
• "L" Bolt
• Plastic Knobs (3)
• Tree Clips (4)
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1–800–743–4115.
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-743-4115.
To prepare your pressure washer for operation, you
will need to perform these tasks:
1. Fill out and send in registration card.
2. Attach handle with chemical reservoir assembly to main
unit.
3. Connect chemical hose to pump.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect ProjectPro™ nozzle to
nozzle extension.
Attach Handle and Accessory Tray
1. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 1).
Figure 1 — Attach Handle to Base
Align Holes
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
6
Handle
Handle
Supports