Additional Safety Instructions; Reducing Dust Exposure; Overview - Cibo Finitube SMFT 2018 Manual

Manual
Finitube
b) Never place your hand near the rotating
accessory. Accessory may kickback over your
hand.
c) Do not position your body in the area
where the power tool will move if kickback
occurs. Kickback will propel the tool in direction
opposite to the grinding wheel's movement at
the point of snagging.
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and sna-
gging the accessory. Corners, sharp edges or
bouncing have a tendency to snag the rotating
accessory and cause loss of control or kickback.
and cause loss of control or kickback.

5.3 Additional Safety Instructions

WARNING
Always wear protective goggles.
Wear ear protectors!
Observe the specifications of the tool or acces-
sory manufacturer!
Grinding belts must be stored and handled with
care in accordance with the manufacturer's
instructions.
The workpiece must lay flat and be secured
against slipping, e.g. using clamps. Large work-
pieces must be sufficiently supported.
Damaged tools must not be used.
Avoid damage to gas or water pipes, electrical
cables and load-bearing walls (static).
Pull the plug out of the socket before making
any adjustments, converting or servicing the
machine.
A damaged or cracked side handle must be
replaced. Never operate a machine with a defec-
tive side handle.

5.4 Reducing dust exposure

Observe the relevant guidelines for your material,
staff, application and place of application (e.g. oc-
cupational health and safety regulations, disposal).
Use a suitable extraction unit.
Reduce dust exposure with the following
measures:
- Do not direct the escaping particles and
the exhaust air stream at yourself or nearby
persons or on dust deposits.
- Use an extraction unit and/or air purifiers.
- Ensure good ventilation of the workplace
and keep it clean using a vacuum cleaner.
Sweeping or blowing stirs up dust.
- Vacuum or wash protective clothing. Do not
blow, beat or brush.
6.

OVERVIEW

See page 2.
1 Support
2 Drive wheel
3 Bumper
4 Round handle
5 Runner wheel
6 Side handle
7 Sliding on/off switch
8 Handle
9 Electronic signal indicator
10 Speed adjustment wheel
11 Switch-on lock
EN
Finitubel Ι 31