How To Use Your Espresso & Cappuccino Maker - Imusa GAU-18201 Manual De Instrucciones

Note: Always make sure the cap is securely tightened before turning the coffeemaker on.
•
Place the filter basket inside the filter holder and into the brewing head.
•
Place the empty glass carafe with lid on drip tray directly under the brewing head.
•
Plug into a standard 120 Volt AC outlet.
•
Rotate the function knob to the "cup" symbol (
light indicates that the coffeemaker is on.
•
Brew the water through the appliance without adding coffee grounds. This removes any dust or
residue that may remain in the system from the manufacturing process.
•
The water will start to be released after a few minutes.
•
When brewing stops, turn the function knob to OFF.
•
Unplug unit and allow the coffeemaker to cool.
Caution: Do not remove the water reservoir cap until pressure is completely released. Follow the
"CAUTION: PRESSURE" procedures.
Caution: Do not remove the filter holder at any time while the coffeemaker is under pressure.
Follow the "CAUTION: PRESSURE" procedures.
•
After the coffeemaker has cooled down and all the pressure has been release, remove the filter
holder and filter basket. Rinse the filter basket and filter holder with water.
Caution: The metal parts of the filter holder might still be very hot.
•
Remove the water reservoir cap. Discard the remaining water through the top opening of the
water tank by turning the machine upside down over the sink. Do not immerse the machine in
water. Screw the water reservoir cap back in place.
•
Discard the water from the carafe, wash thoroughly.
HOW TO USE YOUR ESPRESSO & CAPPUCCINO MAKER
Espresso
•
Make sure the control knob is in the OFF position.
•
Open top lid.
•
Remove the water reservoir cap by turning it counter-clockwise.
•
Fill the glass carafe with fresh cold water up to either the 2 or 4 cup mark.
•
Pour the water from the carafe into the reservoir.
•
Close the water reservoir cap by turning clockwise and ensure it is closed properly and tightly so
steam does not escape during the brewing process.
Note: Always be sure the cap is tightened securely before turning the coffeemaker on.
•
Remove the filter basket and holder from the appliance by turning clockwise. With the
measuring spoon, measure the proper amount of espresso ground coffee and place into the
filter basket without packing too tightly.
•
Place filter basket inside filter holder and into the brewing head by pushing it upward so that the
handle of the filter holder is aligned with the symbol "
•
Turn the handle counter-clockwise until it is securely locked.
), which begins the brewing process. The red
" on the front of the brewing head.