Publicidad
Idiomas disponibles
Idiomas disponibles
Salt .......
Salt
The hardness of the water varies from place to place. If
hard water is used in the dishwasher, deposits will form on
the dishes and utensils.
The appliance is equipped with a special softener that uses
a salt specifically designed to eliminate lime and minerals
from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is
located beneath the lower
rack and should be filled
as follows:
1. Remove the lower rack
and then unscrew and
remove the cap from the
salt container;
2. If you are filling the
container for the first time,
fill it with water;
3. Place the end of the
funnel (supplied) into the
hole and introduce about
2 kg of salt. It is normal for a small amount of water to
come out of the salt container.
4. Carefully screw the cap back on.
The salt container should be filled after about every
30 wash cycles.
To prevent the formation of rust, load the salt just before
beginning a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount
of salt consumed based on the harness of the water used.
This is intended to optimize
and customize the level of salt
consumption so that it remains
at a minimum.
Your Local Water Board can
supply the degree of hardness
of the water
in your area.
To adjust salt consumption,
proceed as follows:
1) Unscrew the cap from the salt container.
2) There is a ring on the container with an arrow on it (see
figure to the side), if necessary, rotate the ring in the anti-
clockwise direction from the "_" setting towards the "+"
sign, based on the hardness of the water being used.
It is recommended that adjustments be made in accord-
ance with the following schema:
Hardness of the water
°dH
°fH
°mmol/l
0 - 10
0 - 17
0 - 1.7
10 – 25
18 – 44
1.8 – 4.4
25 – 50
45 – 89
4.5 – 8.9
> 50
> 89
> 8.9
13
Selector
Salt
knob
consumption
position
(grams/cycle)
/
0
-
20
MED
40
+
60
Autonomy
(cycles/2 kg)
/
60
40
25
EN
Publicidad
