Tabla de contenido
Publicidad
- After having chosen the correct location for the appliance, drill two Ø 6 mm holes in the wall, keeping a distance
of 66 mm between them (fig.1)
- Insert the dowels and fix the nylon support provided with the appliance in the lower hole (fig.2)
- Insert the wall-holder on the nylon support and fix it to the wall through the A hole (fig.3).
If it is preferable to connect the hair dryer directly to the electric network:
- Open the wall holder removing the screws on the back.
- Remove the power cable loosening the 2 screws E. (fig.4)
- Remove the B round part on the back side/left of the wall support (it can be knocked off with a screw driver)
(fig.4)
- Thread the network cables through this part and fasten them to the terminal with the 2 screws E (fig.4).
Close the support to the wall with the screws on the back.
Warning: this operation must be carried out by a qualified electrician.
DIRECTIONS FOR USE
Air flow and temperature can be adjusted by the switch G (fig.3) located on the handgrip:
MAX position - high power - 1200 W - max. air flow
MIN position - low power - 600 W - min. air flow
The push-button 1 (fig.3) is a safety device: the air dryer does not work if it is not pressed down.
The main swich located in the wall-holder connects the appliance (ON position) or disconnects it (OFF position).
In case of internal temperature overload, a thermostat to protect the resistor, with automatic reset, momentarily
interrupts the operation of the resistor and motor.
In case of excessive over-heating, a thermo-fuse interrupts the resistor and then the motor. Both devices ensure
greater safety of operation to the user.
SAFETY AND MAINTENANCE INSTRUCTIONS
- Make sure that the voltage of your electricity supply is the same as indicated on the appliance's rating plate on the
handgrip.
- When using the hair dryer, follow the general safety rules. After using, always disconnect the appliance by the
switch F located on the wall holder ("OFF" position).
- Always switch off the hair dryer for cleaning. Care should be taken to prevent hair from entering the rear grill and
check it is free of dust.
- When in use, do not use spray products.
- Clean the plastic parts by a wad moistened with water and soap. Do not use abrasive products.
Should the above instructions not be followed or in case of inadequate use, the manufacturer will not be
responsible for damages to people or things.
GENERAL WARNINGS
• Do not use this product for anything other than its original purpose, and therefore as hair dryer for hotels
• Do not leave the device exposed to the elements such as rain, sun, etc...
• Do not make any sort of changes to the device
• Do not obstruct the air outlet
• Do not obstruct the air inlet grid
• Do not introduce any object inside the grid or air outlet
• In case of failure and/or malfunctioning disconnect the device from the mains power and contact the manufacturer
or retailer.
• The appliance is not suited for persons (as well as children) physically, mentally, sensory disabled, or with no
experience, unless they have been supervised or directed by someone responsible of their safety.
• If the power supply cord is damaged avoid to use it. Let the Manufacturer or some similar qualified person replace
it, in order to avoid any risk.
• The appliance is not suited for persons (as well as children) physically, mentally, sensory disabled, or with no
experience, unless they have been supervised or directed by someone responsible of their safety.
• If the power supply cord is damaged avoid to use it. Let the Manufacturer or some similar qualified person replace
it, in order to avoid any risk.
GUARANTEE
This appliance is guaranteed for a period of two years from the date of purchase to be proved by a purchase receipt
or an invoice together with the dealer stamp.
This guarantee does not cover the damage resulting from:
* Misuse of the appliance, incorrect use or negligence.
* Accidental breakages due to transport or appliance fall not imputable to the supplier.
* Wrong connection to a voltage other than the one specified, voltage fluctuations on the mains.
* Improper tampering with appliance.
The appliances to be repaired during the period of guarantee must be sent to the manufacturer carriage paid.
5
Publicidad
Tabla de contenido
