Bevel Cut - Skil 3316 Instrucciones De Funcionamiento

SM 2610017175 08-11:SM 2610017175 08-11.qxp 8/2/11 11:24 AM Page 48
Saw Operations
• A bevel cut is made at 0° miter and any bevel angle in the
range of 0° to 45°.
• There are two (2) factory set bevel stops at 0° and 45°.
(See Adjustment section if adjustments are required.)
• The bevel scale faces the operator for easy reading.
Follow these instructions for making your bevel
cut:
WARNING
conducting a simulated cutting cycle, and observe the
projected path of the saw blade. Keep hands at least six (6)
inches away from the projected path of the saw blade.
WARNING
proceeding, so head does not unexpectedly shift in use.
1. Loosen the bevel lock knob 1 (Figure 29). Rotate the
blade to the desired bevel angle using the bevel index 2.
Tighten bevel lock knob (Figure 30).
2. Properly position workpiece. Make sure work piece is
clamped firmly against the table and the fence.
WARNING
on, lower head assembly to make sure clamp clears guard
and head assembly.
3. Activate the switch. Lower the head assembly and make
your cut.
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.

Bevel Cut

Be aware of the path of the saw blade.
Make a dry run with the saw OFF by
When bevel cutting remember to "lock"
cutting head in every position before
Use clamping position that does not
interfere with operation. Before switching
1
See Warnings on page 5
Voir les avertissements à la page 12
Consulte las advertencias que están en la página 19
48
FIG. 29
FIG. 30
2