Cleaning The Oven Door; Sliding Rack Kit Assembly; Replacing The Light Bulb - Hotpoint Ariston FT 850.1/HA S Manual De Instrucciones

Cleaning the oven door

GB
Clean the glass part of the oven door using a sponge and
a non-abrasive cleaning product, then dry thoroughly with
a soft cloth. Do not use rough abrasive material or sharp
metal scrapers as these could scratch the surface and cause
the glass to crack.
For more thorough cleaning purposes, the oven door may
be removed:
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.

Replacing the light bulb

! Do not use the oven lamp as/for ambient lighting.
*
Only available on certain models.
26
1. Open the oven door fully (see
diagram);
2. Lift up and turn the small levers
located on the two hinges (see
diagram);
3. Grip the door on the two external
sides and close it approximately
half way. Pull the door towards you,
lifting it out of its slot (see diagram).
To replace the oven light bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb
and replace it with a similar
one: Wattage 25 W, cap E 14.
3. Replace the glass cover
(see diagram).

Sliding rack kit assembly*

A
Left
Right guide
guide rail
rail
B
C
D
! Do not place the sliding racks in position 5.
To assemble the sliding
racks:
1. Remove the two frames,
lifting them away from the
spacers A (see figure).
2. Choose which shelf to use
with the sliding rack. Paying
attention to the direction in
which the sliding rack is to
be extracted, position joint B
and then joint C on the
frame.
3. Secure the two frames
with the guide rails using the
holes provided on the oven
walls (see diagram). The
holes for the left frame are
situated at the top, while the
holes for the right frame are
at the bottom.
4. Finally, fit the frames on
the spacers A.