TL2000-R User Manual
Specifications:
LED:
Lumen:
Colour Temperature:
Colour Rendering Index:
Housing:
Lens & reflector:
Protection Class :
Voltage:
USB Powerbank:
Battery type 6 x 18650:
Charging Time / Run time:
Charger type:
Operating Temperature:
Lamp Measurements:
Lamp Weight:
Illuminant
Guidance for use:
Use the adjustable foot as a hanger or to adjust the inclination of the light to the desired position.
The lamp has 3 switching stages: Power saving(40%) / Full power(100%) / Off.
Low battery warning: The light will flash 4~6 times about 10 minutes before battery runs out.
Battery level can be checked anytime by pressing the red button next to the connector for the charger.
The lamp is partially charged when delivered.
• Charge the battery fully before first use
• Charging indicator on lamp: 5 green diodes, flashing indicates at what level the battery is
charged.
WARNING
The light from this lamp is very powerful and should not be pointed directly into anyone's eyes, as this may
cause short term blindness. If the beam does shine in your eyes, close them and look away immediately. In
the case of commercial use, the user of the lamp should only use this product in accordance with any local
laws and regulations. The symbol shown on the right means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its
life. The Waste of Electrical and Electronic Equipment (WEEE) Directive has been put in place to recycle
products using best available recovery and recycling techniques to minimize the impact on the environment,
treat any hazardous substances and avoid the increasing landfill.
Devices bearing the adjacent symbol must not be disposed of with household waste.
Please remove all batteries and dispose of these in an environmentally friendly manner. Return the device to
the local collection point for waste electronic equipment or to the manufacturer/importer, who will dispose of
the device in an environmentally friendly manner.
June 2019
20W SMD LED
2000 / 800
6000K
CRI 80+
ABS plastic with rubber bumper
Durable polycarbonate
III (lamp) / II (charger) / IP65 (lamp) IP20 (charger) / IK08
Input: AC110-240V 50-60Hz 0.35A / DC12.6V – 0.95A
Output: 5V / 1A
11.1V – 4000mAh – 44.4Wh
5.5 hours / 2.5 hours (2000lm) – 6 hours (800lm)
1m cable with OD5.45 mm jack for charging pin ID2.0mm, EU 2 pin /
UK 3 pin
-10 ~ +40
23.9 x 7.2 x 20.3 cm
895 g (excl. charger), 978 g (incl. charger)
17W,63xSMD
(2)
(GB)
RoHS
www.elwis.com