PAPILLON ASSO 260 Manual De Instrucciones página 18

mod. ASSO 260 - cod. 96721
ILLUSTRATION AND EXPLANATION OF SYMBOLS
1) Wear hearing and eye protection devices
2) Beware: danger! Read the use instructions
3) Do not expose this electrical tool to rain
4) Keep people and animals away from the work area
5) If the power cable is damaged or cut, remove the plug immediately
a) General warnings
Important: when using electrical tools, in order to prevent various types of
danger, always observe the following safety instructions. These instructions must
therefore be read before using the machine.
Take the environmental conditions into account. Do not expose electrical tools to rain
•
and do not use them in wet or very humid places. Always try to work in good light. Do
not use electrical tools near inflammable liquids or gas.
Keep children out of the way. Do not use the appliance when other people are present
•
especially children or pets. Other people (children) or animals must not be within a 5
metre radius.
Store non-operating tools in a safe manner. Tools not in use must be kept in a safe,dry
•
place, so that they are not accessible, especially to children.
Disabling the tool. Always unplug the tool from the socket when it is not being used or
•
before attempting any repair job and/or any change of consumable tools.
Do not use the tool if you are tired and/or in poor health.
•
Expert, responsible people. Entrust the edge cutter only to people who know it and know
•
how to use it, always handing them the use instructions.
b) Warnings to ensure safe use
Do not overload the tool. Do not force the tool to work under stress. You should therefore
•
avoid overloading with respect to the maximum available power. The tool will work
better and more safely within the limits of its rated power, whereas, otherwise, it could
be damaged and produce inaccurate work.
Dress adequately. Wear protective glasses or an eye shield, closed shoes with non-slip
•
soles, adhering work overalls, gloves and hearing protection.
Avoid incorrect use of the power cable. Do not lift the tool with the cable and do not
•
use the cable to unplug from the socket. Protect the cable against high temperatures,
oil, sharp edges, and other abrasive agents.
Avoid unsafe positions. When working, always stay in a safe, well-balanced position.
•
• Look after the tool. To work well and safely, you must always maintain the tool efficient
and clean, as follows:
1) Observe the instructions on maintenance and on changes of accessories and/or
consumable tools.
2) Regularly check the cable and, if it is damaged, have it replaced by a specialised
technician. Make sure that extension cables are suitable and undamaged and fully
unwound from the winding drum (with a minimum diameter of 1 mm
Always keep the grips dry and free of oil or grease.
).
2
- 18 -