Maintenance And Cleaning; Fault Detection; Disposal - Vortice VORT JET-A Manual De Instrucciones

ENGLISH

Maintenance and cleaning

always wear appropriate protective clothing (including hard hats, eye protectors and ear defenders) when work ̇ n g
N.B
in the vicinity of the fan assembly.
Periodically check the screw connections, the coil resistance, the functionality of the safety components and the controls.
Clean the fan only manually, with a vacuum cleaner or compressed air. Before starting service, maintenance or repair
operations, disconnect the electrical connections and stop the impeller. The fan must be cleaned if necessary at least once
a year to preserve its capacity. Fan bearings are maintenance-free and should only be replaced if necessary. Cleaning must
be done without removing or damaging the impeller. Make sure the ventilator does not emit any suspicious noise.
In addition to routine maintenance, engine bearings require special attention in the long run. If automatic lubricants are
applied to the motor bearings, it is necessary to periodically use a type of quality according to the information on the fan
or motor nameplate and / or the instructions supplied.

Fault detection

It is necessary to turn off the fan before checking the fan and the system. During maintenance, device electrical connections
should be cut entirely. All switches and circuit breakers should be locked by brought to the OFF position. Also "DO NOT
START" sign should be placed on the control panel that will consistently stand.
Check that the electrical connections to the unit are secure. Check that the voltage applied at the fan terminals is as speci-
fied on the motor nameplate, and is balanced. Measure the current on each phase (one phase in the case of single-phase
motors) of the motor in turn and check that the current consumption is within the full load current specified on the motor na-
meplate.
Rotate the motor shaft by hand. Investigate any sound of grinding noises, internal chaffing, rubbing or stiffness. Any obser-
ved defect may indicate that the bearings require lubrication or replacement. Ensure that all fixings are secure. Make sure
that the fan blade is not blocked by an object, if fan is still not working, contact your supplier.

Disposal

IN CERTAIN EUROPEAN UNION COUNTRIES THIS PRODUCT DOES NOT FALL WITHIN THE REQUIREMENTS OF
THE NATIONAL LAWS IMPLEMENTING THE WEEE DIRECTIVE, AND IN THESE COUNTRIES THE PRODUCT IS NOT
SUBJECT TO SEPARATE DISPOSAL OPERATIONS AT THE END OF ITS WORKING LIFE.
Important
This product conforms to EU Directive EU 2012/19/EC.
This appliance bears the symbol of the barred waste bin. This indicates that, at the end of its useful life, it must
not be disposed of as domestic waste, but must be taken to a collection centre for waste electrical and
electronic equipment, or returned to a retailer on purchase of a replacement.
It is the user's responsibility to dispose of this appliance through the appropriate channels at the end of its
useful life. Failure to do so may incur the penalties established by laws governing waste disposal.
Proper differential collection, and the subsequent recycling, processing and environmentally compatible disposal of waste
equipment avoids unnecessary damage to the environment and possible related health risks, and also promotes recycling
of the materials used in the appliance.
For further information on waste collection and disposal, contact your local waste disposal service, or the shop from which
you purchased the appliance.
Manufacturers and importers fulfil their responsibilities for recycling, processing and environmentally compatible disposal
either directly or by participating in collective systems.
14