Scubapro Nova 720 Manual Del Usuario página 3

926- Nova light 720 - totale.indd 3 926- Nova light 720 - totale.indd 3
INSTRUCTIONS
To turn ON the SCUBAPRO Nova 720 turn the
light head counter clock-wise and the light body
clock-wise until it is fi nger-tight and the light turns
on. Make sure to not over tighten the casing
as this could result in premature wear and/or
damage to the O-rings.
*NEVER USE A TOOL OF ANY KIND TO
TIGHTEN THE CASE*
To turn OFF the Nova 720 slowly turn the light
head clock-wise until the light turns off. Once the
light is off, do not turn the casing any further.
If the casing is unscrewed too far, fl ooding may result.
To switch between the 100% and 50% mode
turn the light off and on again.
! WARNING
Do not look directly into the light, or direct
the light into the eyes of others. Do not
alter or modify the dive light. If modifi cation
causes water entry or other malfunctions,
the warranty will be void.
The light is fi tted with an overpressure
valve for your safety. In case the battery
produces gas leading to a high internal
pressure of the light, the valve will open.
This could cause water to enter the light.
Proper storage: if the dive light is not to be
used for a long period of time, remove batteries
to avoid accidental leakage.
Proper maintenance: frequent use of the dive
light may cause O-rings to dry out. To avoid
leakage, clean O-ring groove with a cotton
swab and regularly apply lubricant to O-rings
to help prevent dry cracking. Please rinse the
Nova 720 with fresh water before storing.
3
24/09/2015 11:41:16 24/09/2015 11:41:16