Publicidad
MIXER REAR PANEL
1. POWER CONNECTOR
Connect the supplied power cable here.
2. FUSE HOLDER
The fuse can be found here. Please note, if blown
this should only be replaced by a qualified
technician. If the fuse continues to blow after
replacement do not use this mixer until it is
repaired.
3. VOLTAGE SELECTOR
Use these outputs to connect passive speakers to
the media player.
SETUP
In order to correctly setup the system please use
the following steps.
1. Ensure that you have positioned the speakers far
enough apart to achieve an accurate stereo field
and place the mixer in the middle.
2. Insert the speaker cables into the speaker output
at the rear of the mixer.
3. After checking that master and channel volumes
are turned fully down, connect your microphones
and instruments to the appropriate channels on
the mixer.
4. Connect the mixer to the mains using the
provided IEC power cable and switch on.
5. Gradually increase the volume of the master
control and each channel until you reach the
desired level without introducing distortion.
Please note: It is strongly recommended that
you install your speakers onto tripod stands to
achieve maximum dispersion. When positioning
microphones avoid placing them directly in front of
the speakers to minimise the risk of feedback.
1
8
2
3
Publicidad
