Maintenance - PANCONTROL PAN LAN1 Manual

MODE Function
Press the MODE button to select the desired function.
(AC, DC, mA, µA, ,

9. Maintenance

Only authorized service technicians may repair the instrument.
Note: If the instrument is malfunctioning, please test:
- Battery condition and polarity
- Condition of the fuse(s) if available.
- Condition of the test leads.
Changing the battery(s)
Replace the battery(s) when the battery symbol or BATT is displayed on the
LCD.
Attention: Remove test leads from any power source and turn the device
OFF before opening the cover!
1. Remove the protective cover and the screws of the battery or fuse
compartment using a proper screwdriver and remove the lid.
2. Replace the battery. Mind the correct polarity.
3. Replace the battery compartment lid and secure the screw.
4. Disposal of the flat battery should meet environmental standards.
5. Remove the battery if the device is not used for a long time.
Checking the fuse(s) in the unit
Set the rotary switch to the continuity test position. Connect one test lead to
the V jack and touch the 10A or mA jack electrically with the probe.
°) If the buzzer buzzers, the fuse is all right.
°) If "OL" or "1" is displayed, the fuse(s) needs to be replaced.
)
EN 15