Descargar Imprimir esta página

Zamel exta free P-256/36 Manual De Instrucciones página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 17
OPERATION
After pressing the push-button the remote control sends a signal on
868 MHz which controls EXTA FREE receivers. Device programming
procedure (adding a transmitter to the transmitter's memory) is
described in manual instruction of particular EXTA FREE system
receivers. The range (up to 300 m depending on a receiver) can be
changed by means of a retransmitter or few RTN-01 retransmitters.
TRANSMITTER'S OPERATION
By means of buttons ,
bank is indicated by a switched on single LED diode at the bank
number (for banks from 1 to 5), selecting bank number 6 is signalled
by all 5 LED diodes.
While pressing the control buttons from 1 to 6 radio commands are
sent. The above is indicated by a flashing LED diode at the selected
bank number when the button is pressed and released (the excep-
tion is the flashing LED of bank 2 and 4 while transmitting a com-
mand from bank 6).
The repeated LED diode flashing while pressing and releasing the
control button indicates the low battery status in the transmitter. It
must be replaced.
Caution: Bank 6 is dedicated to realise the central control function
(central switching on or switching off of a few receivers or roller
blinds), but at the same time it can be used as a simple bank with
control buttons.
BATTERY CHANGE
Battery discharge status is signalled by several LED red diode
flashes during transmission time.
Remove the screws from the bottom part of the remote control.
Remove the upper cover with the silicon keyboard.
Remove the battery from the latch.
Mount a new battery. Watch battery polarisation marked on the
latch. Wrong battery mounting may cause device damage.
Place back the top cover with the keyboard and tighten the screws.
CAUTION: While changing the battery, it is suggested to press any of the but-
tons for about 5 seconds before putting it into a latch. Next press transmission
button several times to check its operation. If the transmitter does not work
properly repeat the battery change procedure.
SUBSTITUTING THE BATTERY WITH ANY BATTERY OF
INCORRECT TYPE MAY CAUSE AN EXPLOSIVE HAZARD.
DISPOSE OF USED BATTERIES AS STATED IN THE MANUAL.
choose the bank of buttons. The selected

Publicidad

loading