Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
G B
I E
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf blower
cannot be started later.
5. Dismantle the blow tube (9) by
releasing the lock (8) and pulling
off the blow tube forwards.
Assembling/dismantling the
two-piece suction tube
Never use the leaf vacuum
with only one suction tube
section attached. There is a
risk of personal injury!
After the two-part suction
tube has been assembled, it
must not be divided up again
into two parts!
1. Remove the protective cover of
the suction opening by unscrew-
ing the screw with star grip (18)
and turning the protective cover
anti-clockwise and removing it.
2. Assemble the two suction tubes
(16) as illustrated. The parts can
be felt to lock into place.
When putting it together, make
sure that the symbols (
upper and lower suction pipe
interlock.
3. Place the suction tube (16) on
the underside of the motor hou-
sing (1). Turn the suction tube
clockwise as far as it will go.
4. Attach the suction tube by tighte-
ning the screw with star grip (13)
in the holder.
3 2
) at the
A
B
C
K
L
M
U
V
W
The screw with star grip has to be
tightened as far as it will go by
hand, as otherwise the leaf vacuum
cannot be started later.
5. Dismantle the suction tube (16)
by releasing the screw with star
grip (13) und turning the suction
tube anti-clockwise.
Installing/removing the
collection bag
In suction mode the device can only
be operated with the collection bag
installed.
The ventilation opening on the collection
bag (
20) serves for an improved air
A
B
C
D
E
circulation.
K
L
M
N
O
1. If necessary, remove the blower
U
V
W
X
Y
tube (
dismantling the two-piece blow
tube").
2. Push the catcher (14) on to the
blower outlet of the motor hou-
sing (1) until this snaps into place
in the locking device (8).
3. Hang the fastening hook (15) of
the collection bag (14) on the
holding points (19) provided on
the suction tube.
The additional handle (10) can be lo-
D
E
cked in various positions. In order to
change the handle position, release
the screw with star grip (17), change
N
O
the handle position and tighten the
screw again.
X
Y
F
G
H
I
P
Q
R
S
Z
A
9) (see „Assembling/
B
C
D
K
L
M
N
U
V
W
X
F
G
H
P
Q
R
Z
J
T
E
F
G
H
O
P
Q
R
Y
Z
I
J
S
T
I
S
Publicidad
Capítulos
Tabla de contenido
