Operating Components; Handling And Operation; Charging The Battery; Using The Brush Heads - Nevadent NZAE 3.7 A1 Instrucciones De Uso

Operating components

(See fold-out page for illustrations)
Brush head
1
Drive shaft
2
On/Off button + programme selection button
3
Charging indicator lamp
4
Charger
5

Handling and operation

This section provides you with important information on handling and using the appliance .

Charging the battery

♦ Connect the charger 5 to a mains power socket .
♦ Place the switched-off handset on the charger 5 . The charging indicator lamp 4
lights up red during charging . It takes approximately 10 hours for the empty battery
to be fully charged . Once the handset is fully charged, the charging indicator lamp 4
lights up green .
♦ If the charging indicator lamp 4 starts flashing red, the battery is empty and needs
to be recharged .
NOTE
► Place the handset back on the charger 5 after use . This ensures that your tooth-
brush always operates at its optimum performance . The battery is not damaged
by regular charging .

Using the brush heads

2 brush heads 1 are supplied with the appliance . Before first use, clean the brush
heads 1 in fresh running water .
♦ Take a brush head 1 and insert it from above onto the drive shaft 2 of the handset .
Ensure that the drive shaft 2 slides precisely into the socket on the brush head 1 .
Push the brush head 1 down until it completely covers the drive shaft 2 .
♦ To remove the brush head 1, pull it upwards and off the drive shaft 2 .
■ 6
│ GB │ IE
NZAE 3.7 A1