AGV VELOCE S Manual De Instrucciones página 19

ASSEMBLING THE PINLOCK ANTI FOG LENS
®
After removing the visor from the helmet, place the Pinlock anti fog lens inside it, with the silicone seal facing
®
the inside of the visor.
Insert the notch on the left side of the lens onto the pin located inside the visor on the left side (19), then flex the
lens slightly (20) and insert the right notch onto the right pin of the visor.
21 Check that that silicone seal on the Pinlock anti fog lens adheres tightly to the visor along the whole of the
®
perimeter of the helmet (22).
Remove the protective film from the Pinlock anti fog lens and fit the visor on the helmet.
®
Important. The Pinlock anti fog lens must be handled with care to prevent scratches or
®
abrasions from forming on its surface.
REMOVING AND CLEANING THE PINLOCK ANTI FOG LENS
®
To remove the lens repeat the operations (20 and 19) in reverse order.
Clean the Pinlock anti fog lens using mild soap, warm water and a moistened soft cloth. Allow it to dry
®
Important. NEVER USE ABRASIVE
thoroughly for at least one day before repositioning it.
CLEANING PRODUCTS OR LIQUIDS CONTAINING AMMONIA OR ALCOHOL.
ASSEMBLING THE TEAR OFFS
The tear off is used to protect the visor from dirt that can accumulate while riding and to keep it clean by removing
the strip as required by tearing it off.
Important. Make sure to remove the protective film on both sides before fitting the tear
off on the visor.
Before installing the tear off rotate the eccentric pawls, moving them toward each other; then fasten the tear
off to the pawls (23) with the tear-off tab on the side of the helmet you prefer. To make the tear-off tab easier to
grasp, the tear off can be bent slightly to the outside, so that it does not adhere fully to the helmet. Then rotate the
eccentric fastening pawls (24) to tighten the tear off and make it adhere correctly to the visor. Finally, according
to your needs, a second tear off can be applied over the first one, with the tear-off tab on the side you prefer.
REMOVING/FITTING THE NOSE GUARD
Remove the nose guard by pulling it upward (25).
To reposition, insert the fastening tooth into the special housings and press until it snaps into place.
REMOVING THE WIND BREAK
Slide out the part of the wind break inserted between the outer shell and the chin guard (26).
To replace it, repeat the operations in reverse order.
REMOVING THE CHEEK PADS AND NECK ROLL
To remove the cheek pads, hold them in front near the chin guard and pull them in the direction of the arrow
to free them from the press studs (27). Slide the plastic flap out of its position and remove the cheek pads (28).
To reposition, repeat the previous operations in reverse order.
REMOVAL/INSTALLATION OF THE EAR CUSHIONS
A couple of ear cushions (39) are installed in the cheek pads (40) of the helmet.
Pull out the cheek pad by acting on the buttons to remove the ear cushions (41) and extract them.
Align the holes with the back buttons of the cheek pad to insert the ear cushions back and reposition the cheek
pads (42). Check to make sure the cheek pads are firmly attached to the helmet.
19