AGV VELOCE S Manual De Instrucciones página 20

REMOVING THE CROWN PAD
To remove the crown pad, undo the buttons at the front (29) then at the rear (30).
Reverse the process to fit the pad.
WASHING THE INNER PARTS
After having removed the inner parts, the crown pad and cheek pads can be hand washed in warm water with mild soap.
After washing, rinse in running water. Do not wring and dry at room temperature away from direct sunlight.
OPENING/CLOSING THE CHIN GUARD AIR VENTS
To open/close the chin vent, raise/lower the mechanism inside the vent (33,34,35).
OPENING/CLOSING THE FRONT AIR VENTS
The helmet has n° 3 air vents arranged in the front area of the helmet above the visor.
The air vents are opened and closed with an opening/closing mechanism.
The air vents are opened by pushing the slider upward (36) while the vents are closed by pulling the slider
downward (37).
REAR EXTRACTORS
The rear area of the helmet is provided with n° 2 extractors, which are always open due to their structure and
position and allow air to be removed from inside the helmet with a proportional effect as speed increases.
RESCUE PULL SYSTEM
It's a mechanism that can be used by emergency personnel to remove the cheek pads. In case of emergency,
the chinstrap must be cut or untied to remove the cheek pad. Grab the red emergency ribbon, while holding the
helmet to prevent the pilot's head from moving (31), and pull on it in the direction shown (32). Pull on the red
ribbon to release the automatic buttons and to extract the helmet's cheek pad while it is still on the driver's head.
Repeat this procedure to remove the other side. Hold on tightly to the helmet and do not move the pilot's head
while removing the cheek pads.
Warning:
1) Do not pull on the emergency red ribbon while driving.
2) Only use original AGV cheek pads and never non-AGV components.
3) Do not use the Rescue Pull System to remove the cheek pad for maintenance.
COMPONENT LIST
_ 38
1. VISOR
2. CENTRAL AIR VENT
3. SIDE AIR VENT
4. VISOR MECHANISM
5. TEAR-OFF PAWL / PINLOCK
6. BASE EDGE
7. AIR VENT ON CHIN GUARD
SILICONE OIL:
Silicon oil to lubricate the visor's mechanism and to avoid rust and annoying noises.
Remove the visor before applying the product. Then, apply a small amount of oil on the visor's actuator system. Remove excess
oil with a cloth. Your view can be obstructed if there are silicone oil residues on the visor. Ensure adequate lubrication.
Warnings:
1) Wash with plenty of soap and water in case of contact with skin.
2) Wash with plenty of water and seek medical advice in case of contact with eyes.
8. VISOR OPENING BUTTON
9. NOSE-GUARD
10. WIND BREAK
11. RETENTION SYSTEM
12. CROWN PAD
®
13. CHEEK PADS AND NECK ROLL
14. REAR EXTRACTORS
20