Zanussi Professional ZXLIG Instrucciones De Operación página 19

ENGLISH
Anomaly
Glasses and dishes are not
dried properly.
Condensation on glasses.
Stains on the glasses.
Excessive foam in the tank.
Smears or spots on the
glasses.
Low pressure from wash arms. Loss of
Low pressure from rinse arms. Loss of
The wash pump does not
work.
The drain pump does not
work.
The dishwasher is switched
off, but the appliance contin-
ues to fill water.
18
Type of Possible causes
anomaly
Loss of The container of rinse aid is empty. Check that there is rinse-aid in the
performance.
Rinse aid pump does not work.
The rinse water temperature is too
low.
Foamy detergent present in the
wash tank.
Loss The container of rinse aid is empty. Check that there is rinse-aid in the
performance.
Rinse aid pump does not work.
Foamy detergent present in the
Loss of
performance. wash tank.
The dosing of rinse aid is not
correct.
the hardness of the water is too
high or too low.
Loss Residuals of food or detergent,
performance.
used for manual prewash, remains
in the dishes.
Wash water temperature is too low. Check if the water temperature of the
Foamy detergent present in the
wash tank.
Too much rinse-aid.
The tank filter is clogged.
performance
The wash pump filter is clogged.
The water drainage hose is
clogged.
The wash pump does not work
properly.
The rinse arms are clogged.
performance
The water pressure after pressure
reducer is less than 1 bar.
Blocking The wash pump is clogged.
Loss of The drain pump is clogged.
performance
Inlet valve is damaged.
Loss of
performance
Actions
container and if necessary top it up.
Call detergent and rinse aid service
centre.
Check if the rinse water temperature
is between 82℃ - 90℃.
Call detergent and rinse aid service
centre to set the temperature in
according to the rinse aid
specifications.
Check if the dishes were not
immersed in foamy detergent (e.g.
hand wash detergent) before being
put in the dishwasher.
Only use "non-foaming" products for
professional dishwashers.
container and if necessary top up.
Call detergent and rinse aid service
centre.
Only use "non-foaming" products for
professional dishwashers.
Call detergent and rinse aid service
centre.
Adjust the amount of detergent and
rinse aid.
Call detergent and rinse aid service
centre.
Remove residuals of food or detergent
from the dishes.
wash module is between 55℃ - 65℃.
Call detergent and rinse aid service
centre to set the temperature in
according to the detergent
specifications.
Empty and refill the tank with water
until the foam has been removed.
Reduce the amount of rinse-aid.
Call detergent and rinse aid service
centre.
Clean the tank filter.
Clean the wash pump filter.
Call service centre.
Call service centre.
Clean the rinse arms.
Call service centre.
Call service centre.
Call service centre.
Close the water supply tap or taps and
call service centre.