Spectro-UV Spectroline uVision Serie Manual De Instrucciones página 2

UV emitted from this product. Avoid eye and skin exposure to unshielded products.
IMPORTANT SAFETY INSTRUCTIONS (Read all instructions)
• Do not operate the uVision™ Series UV-A/White Light LED NDT Inspection Lamp
(UV-365SBLCR) if the lamp has been damaged.
Do not look directly into the light. ALWAYS wear the UV-absorbing protective glasses
•
provided when operating the lamp. Use in low-light conditions to achieve the best
inspection results. The darker the room, the greater the fluorescent contrast.
• The uVision™ is not approved for use in hazardous atmospheres. Do not attempt to use
it in areas requiring explosion-proof lighting.
• Never use this equipment in any manner not specified in these instructions because
your protection may be impaired.
• NEVER aim the lamp in the direction of another human being. It is meant for
professional fluorescent inspections ONLY!
• DO NOT attempt to modify the lens assembly or light output. Doing so may alter the
performance and intensity of the uVision™.
OPERATION
• The uVision™ series UV-A inspection lamps are equipped with a 50 ft. (15.3 m) heavy-
duty power cord and retractable reel.
• The lamp is shipped with the correct cord installed for the country of destination.
• Connect the plug to a power source that complies with the electrical requirements
specified on the label.
• The lamp has a three-position rocker power switch (II – UV; O – off; I – white light) on
the handle.
• The UV-365SBLCR has a White Light Intensity Adjustment Control located on the back
plate of the lamp. The Power Indicator is also located on the back plate of the lamp.
The Power Indicator light will be Orange when the lamp is operating within RRES
compliance.
• The UV-365SBLCR is designed to automatically shut off if the unit operates outside of
RRES compliance standards. To turn the unit back ON from a shut off event, turn the
lamp OFF and then ON using the three-position rocker switch.
• WARNING: Be sure to use genuine uVision™ replacement parts. Using another
manufacturer's replacement parts could affect product performance and will void the
warranty.
Rocker Switch
CHANGING THE LAMP POWER
The appropriate cord for the country of destination will be installed on the lamp when it is
ordered. The power cord is integrated into the lower portion of the lamp handle, forming a
cord/handle assembly. A set of detailed instructions for changing the lamp cord come with
the replacement parts. Contact Customer Service for more details. Call toll-free 1-866-230-
7305.
FOR PROFESSIONAL EXAMINATION USE ONLY
White Light
Adjustment
SUPPLY
WARNING
Intensity
2
Power
Indicator