Publicidad
Idiomas disponibles
Idiomas disponibles
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1
Flush through the supply pipes.
2
Mount the ball S - unions.
3
Fasten the mixer with the washers.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
33400000/33401/33453000: The flow is changed
from bath to shower function by pulling the knob
at the upper side of the spout. After shutting off
the water flow, the mixer returns automatically to
the bath function.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Centre distance:
Connections G ½":
Rate of flow:
anti-pollution function
4
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
150 ± 16 mm
cold right - hot left
ca. 22 l/min 0,3 MPa
English
To adjust the hot water limiter on single lever
mixers, please see page 6.
No adjustment is necessary when using a
continuous flow water heater.
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
Important!
The non return valves must be checked regularly
according to DIN EN 1717 in accordance with
national or regional regulations (at least once a
year).
Spare parts see page 3
1
handle
1.1 screw cover
2
flange
3
nut
4
cartridge cpl.
5
flange
6
S-union
7
aerator cpl.
8
selector assy
9
diverter knob
10
non return valve
11
hose connection
33091000
94191000
94192000
94194000
92730000
94135000
94140000
13914000
94077000
94078000
94074000
96044000
Publicidad
