Oki IP-7900-26 Guía De Consulta Rápida página 25

Replace the dust filters
„ Check that the suction fan filters are not encrusted with
dust.
Inside the Printer, exhaust fan filters also called dust filters are
attached to:
- the four air exhaust outlets of the suction fan with the IP-7900-
20/21; or
- the three air exhaust outlets of the suction fan with IP-7700-20/21
Replace all the dust filters approximately every three months.
When replacing the dust filters from the operation panel menu,
start the procedure from step 1. When replacing while executing
[#START MAINTENANCE], start the procedure in step 6.
You will be prompted to replace the dust filters during the start
maintenance guidance after 3 months or 2.5 km of print length.
1
á R E W I N D F O R M F E E D â
ß P H . R E C
Press the key.
2
# S T A R T M A I N T E N A N C E
>
key select [#MAINTENANCE].
With the
3
# M A I N T E N A N C E
> S P I T T O O N C A S E / U N I T ?
Press the key.
4
# M A I N T E N A N C E
* S P I T T O O N C A S E / U N I T ?
Press the key.
5
# M A I N T E N A N C E
* D U S T F I L T E R ?
Select [DUST FILTER] and press the
6
D U S T F I L T E R C H E C K E D ?
Y E S : O K / N O : C A N C E L
Press the key.
24
Dust filters
P H . M A I N à
key.
7
When the media is installed on the take-up reel
unit, remove the media.
8
By spreading an unnecessary media or cloth on
the floor, prevent the floor from being smeared
with the ink clot dropped from the old suction
fan filters.
9
Remove the old suction fan filters from the hook-
and-loop fastener.
If the old filter's lint is left on the hook-and-loop
fastener, remove it.