Technical Data; Description (Fig. A) - Ferm PDM1052 Manual Del Usuario

accessory is larger than or the same as the
maximum speed of the machine. Refer to the
rating plate on the machine.
• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly
supported or fixed.
• Keep your hands away from the workpiece
during use.
• Never put the machine down on a table or a
workbench before it has been switched off.
Electrical safety
Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.

TECHNICAL DATA

Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. drill bit diameter
Concrete
Protection class
Weight
Noise and vibration
Sound pressure (Lpa)
Acoustic power (Lwa)
Uncertainty (K)
Impact drilling mode
Drill into metal
Uncertainty (K)
Wear hearing protection.
Vibration level
The vibration emission level stated in this
All manuals and user guides at all-guides.com
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned
- using the tool for different applications, or with
- the times when the tool is switched off or when
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns

DESCRIPTION (FIG. A)

. If you use a Your impact drill has been designed for drilling
2
holes in wood, metal and plastics and for hammer
drilling in brick and concrete.
PDM1052
V~ 230
Hz 50
W 800
min 0 - 3,000
-1
min 0 - 48,000
-1
Wood mm 25
mm 13
Steel mm 10
IP 20
kg 2.2
ASSEMBLY
PDM1052
dB(A) 91.7
dB(A) 102.7
dB(A) 3
m/s 15.238
2
Mounting and removing the drill bit (fig. B)
m/s 4,980
2
The machine is suitable for use of the following
m/s 1.5
2
drill bits:
• Wood (HSS)
• Metal (HSS)
• Concrete / masonry (hard metal)
different or poorly maintainted accessories,
may significantly increase the exposure level
it is running but not actually doing the job, may
significantly reduce the exposure level
1. On/off switch
2. Lock-on button
4. Forward/reverse switch
5. Switch for drilling / hammer drilling
6. Chuck
7. Main grip
8. Auxiliary grip
9. Depth stop
10. Chuck key
11. Chuck key holder
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
5