Operation - Berkel B12A-SLC Manual Del Propietario - Operador

General
1. Rotate the pusher out of the way of the product table and place in the stop at the bottom of the
table. Place product to be sliced on the product table. Position the pusher at the end of product.
If­the­product­you're­slicing­is­long,­place­the­pusher­on­top­of­the­product.­The­pusher­will­feed­
the product toward the knife after each slice.
2. Turn the slicer ON.
3.­ The­thickness­control­knob­allows­you­to­vary­the­thickness­of­the­slices­from­paper­thin­to­
approximately­9/16"­thick.­To­make­thinner­slices,­turn­the­thickness­control­knob­to­the­right.­
For­thicker­slices,­turn­the­knob­to­the­left.
4.­ A­handle­is­provided­on­the­product­table­to­move­it­back­and­forth.
5. To­operate­slicer­in­automatic­mode,­change­lever­to­automatic­position­at­9­o'clock.­Turn­the­
slicer­on­by­pressing­the­Blade­Power­Switch­ON,­then­press­the­Automatic­Power­Switch­ON.
6. If­the­meat­pusher­is­not­needed,­store­it­out­of­the­way­by­lifting­it­to­the­top­of­the­Meat­Grip­
Rod and rotating it 270° behind the Product Tray. Allow it to rest on the small notch of the
upper Product Table slot.
NOTE:­The­OFF­switch­can­be­pressed­to­stop­the­slicer.­The­Product­Table­will­stop­moving­immedi-
ately.

Operation

BK45780 (07-21) Owner/Operator Manual • 7