Kiwi KFAN 7512 Manual Del Usuario página 5

ASSEMBLY OF BASE
1. This fan is supplied with a moulded surround which must be fitted to the base of the fan before the
fan is used.
2. The moulded base surround is supplied with 3 off retaining screws (in a small polybag taped to the
inside of the surround)
3. Remove the bag containing the screws and position the surround on the moulded retaining clips
on the base and snap into place. Ensure that the surround has clipped firmly into position onto the
fan base and screw the 3 retaining screws into the holes across the middle of the base. Do not over-
tighten these screws.
ASSEMBLY OF BLADE AND GUARD
1. Un-screw to remove the blade spinner from the motor shaft .
2. Un-screw the guard mounting nut from the front of the motor housing.
3. Position the rear guard against the front of the motor housing with the handle uppermost, ensuring
that the locating pegs on the motor housing are engaged correctly in the holes in the guard.
4. Screw the guard mounting nut firmly onto the projecting thread on the motor housing, make sure
you tighten it firmly.
5. Remove and discard the PVC sleeve on the motor shaft.
6. Place the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin
that pass through the motor shaft.
7. Screw the spinner onto the motor shaft, and tighten it firmly against the front of the blade.
8. Position the front guard against the rear guard so that the holes in the rims that accept the small
nut and bolt are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten at
this stage.
9. Move the guard retaining clips into position ensuring that they engage correctly on the rim of the
guard.
10. Fully tighten the small nut and bolt that passes through the rim of the guard.
Operating instructions
1. Plug the power cord into a suitable socket
2. Tilt the head up or down to the required position by using a locking mechanism that will hold the
head in the desired position.
3. The fan is switched on using the push buttons on the base, i.e.
0 = Off, 1 = Low Speed, 2 = Middle speed, 3= High speed.
Oscillation Control
1. Push the oscillation knob to oscillate 2. Pull the oscillation knob to stop
Special Attention:
1. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
2. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety
3. Children should be supervised to ensure that they do not play with the appliance.
KFAN 7512 User Manual
5