Warning; Work Environment; Rc 120; General - voestalpine Bohler RC 120 Instrucciones De Uso

1 WARNING

Before performing any operation on the machine,
make sure that you have thoroughly read and
understood the contents of this booklet.
Do not perform modifications or maintenance
operations which are not prescribed.
The manufacturer cannot be held responsible for damages to
persons or property caused by misuse or non-application of the
contents of this booklet by the user.
Please consult qualified personnel if you have any
doubts or difficulties in using the equipment.

1.1 Work environment

• This equipment shall be used for professional applications
only, in industrial environments.
The manufacturer shall not be held responsible for any dam-
ages caused by the use of the equipment in domestic environ-
ments.
• The equipment must be used in environments with a tem-
perature between -10°C and +40°C (between +14°F and
+104°F).
The equipment must be transported and stored in envi-
ronments with a temperature between -25°C and +55°C
(between -13°F and 131°F).
• The equipment must be used in environments free from dust,
acid, gas or any other corrosive substances.
• The equipment shall not be used in environments with a rela-
tive humidity higher than 50% at 40°C (104°F).
The equipment shall not be used in environments with a rela-
tive humidity higher than 90% at 20°C (68°F).
• The system must not be used at an higher altitude than 2,000
metres (6,500 feet) above sea level.

2 RC 120

2.1 General

Operation of the remote control is acti-
vated when connected to the power
sources. This connection can be made
also with the system power on.
With the RC control connected, the
power source control panel stays enabled
to perform any modification. The modifications on the power
source control panel are also shown on the RC control and vice
versa.
The output current is controlled from a minimum to a maximum
value (can be entered from SETUP) by varying the foot pressure
on the pedal surface. A microswitch provides the start trigger
signal at minimum pressure.
"Consult the instruction manual".
9