voestalpine Bohler TERRA 150 Instrucciones De Uso página 23

Excessive spatter
Cause Incorrect arc length.
Solution Decrease the distance between the electrode and
the piece.
Cause Incorrect welding parameters.
Solution Decrease the welding voltage.
Cause Insufficient shielding gas.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good conditions.
Cause Incorrect welding mode.
Solution Decrease the torch angle.
Insufficient penetration
Cause Incorrect welding mode.
Solution Decrease the welding travel speed.
Cause Incorrect welding parameters.
Solution Increase the welding current.
Cause Incorrect electrode.
Solution Use a smaller diameter electrode.
Cause Incorrect edge preparation.
Solution Increase the chamfering.
Cause Incorrect earth connection.
Solution Earth the system correctly
Read the paragraph "Installation ".
Cause Pieces to be welded too big.
Solution Increase the welding current.
Slag inclusions
Cause Poor cleanliness.
Solution Clean the pieces accurately before welding.
Cause Electrode diameter too big.
Solution Use a smaller diameter electrode.
Cause Incorrect edge preparation.
Solution Increase the chamfering.
Cause Incorrect welding mode.
Solution Decrease the distance between the electrode and
the piece.
Move regularly during all the welding operations.
Tungsten inclusions
Cause Incorrect welding parameters.
Solution Decrease the welding voltage.
Use a bigger diameter electrode.
Cause Incorrect electrode.
Solution Always use quality materials and products.
Sharpen the electrode carefully.
Cause Incorrect welding mode.
Solution Avoid contact between the electrode and the weld
pool.
Blowholes
Cause Insufficient shielding gas.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good condition.
Sticking
Cause Incorrect arc length.
Solution Increase the distance between the electrode and
the piece.
Cause Incorrect welding parameters.
Solution Increase the welding current.
Cause Incorrect welding mode.
Solution Angle the torch more.
Cause Pieces to be welded too big.
Solution Increase the welding current.
Undercuts
Cause Incorrect welding parameters.
Solution Decrease the welding voltage.
Use a smaller diameter electrode.
Cause Incorrect arc length.
Solution Increase the distance between the electrode and
the piece.
Cause Incorrect welding mode.
Solution Decrease the side oscillation speed while filling.
Decrease the travel speed while welding.
Cause Insufficient shielding gas.
Solution Use gases suitable for the materials to be welded.
Oxidations
Cause Insufficient gas protection.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good condition.
Porosity
Cause Grease, varnish, rust or dirt on the workpieces to
be welded.
Solution Clean the workpieces carefully before welding.
Cause Grease, varnish, rust or dirt on the filler material.
Solution Always use quality materials and products.
Keep the filler metal always in perfect condition.
Cause Humidity in the filler metal.
Solution Always use quality materials and products.
Keep the filler metal always in perfect condition.
Cause Incorrect arc length.
Solution Decrease the distance between the electrode and
the piece.
Cause Humidity in the welding gas.
Solution Always use quality materials and products.
Ensure the gas supply system is always in perfect
condition.
23