Service - SCAN Andersen 4 Instrucciones Para Instalación

5.3 Danger of overheating
The fi replace must never be used in a manner that causes
overheating
Overheating occurs when there is too much fuel and/or
too much air so that too much heat develops. A sure sign of
overheating is when parts of the stove glow red. If this happens,
reduce the air vent opening immediately.
Seek professional advice if you suspect that the chimney
is not drawing properly (too much/too little draught). (For
further information, see "Chimney and fl ue pipe" under 4.0
Installation).
5.4 Ash removal
This product has an ash pan that makes it easy to remove the
ash.
Fig.14
• The product is fi tted with an ash grate (Fig. 14 - 2). Activate
the handle (Fig. 14 - 1) to empty ash out of the burn chamber
into the ash pan (Fig. 14 - 3).
Important! Never empty ash into a fl ammable container.
There may still be embers in the ash long after the fi re has
gone out.
• Make sure that the ash pan (Fig. 14 - 3) never gets so full
that it prevents the ash from falling through the ash grate
and down into the pan.
2
3
1

6.0 Service

Warning! Any unauthorised changes to the product is not
allowed! Only original spare parts may be used!
6.1 Replacing the baffl e/defl ectors
Fig. 15
1. Lift the baffl e (Fig. 15 - 1) up carefully.
2. Remove the pins (Fig. 15 - 2).
3. Ease the baffl e out.
Fig. 16
2
1. Lift the exhaust defl ector (Fig. 16 - 1) up carefully.
2. Remove the pins (Fig. 16 - 2).
3. Ease the exhaust defl ector out.
ENGLISH
1
1
41