Using The Cooler - Dometic CF35 Instrucciones De Uso

CF35, CF40, CF50
This is how to select the battery monitor mode:
➤ Switch on the cooler.
➤ Press the "SET" button (fig. 3 4, page 3) three times.
➤ Use the "UP +" (fig. 3 6, page 3) and "DOWN –" (fig. 3 7, page 3) buttons to
select the battery monitor mode.
✓ The selected mode then appears in the display for a few seconds. The display
flashes several times before it returns to the current temperature.
I
NOTE
When the cooler is supplied by the starter battery, select the battery
monitor mode "HIGH". If the cooler is connected to a supply battery,
the battery monitor mode "LOW" will suffice.
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
6.5

Using the cooler

A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
NOTE
Place the cooler as shown (fig. 1, page 3).If you operate the box in a
different position it can be damaged.
➤ Close the cooler, see chapter "Connecting the cooler" on page 13.
I
NOTE
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
EN
Operation
15