Publicidad
Idiomas disponibles
Idiomas disponibles
cable (64) and by following the arrows
marked on the cable, Fig.24, pass it
through the first pulley (A1), as shown
in Fig.24.
Next, pass the same tip through
lower pulley (B1; C1) Fig.24.
Continue passing the tip of the
cable (64) through the third pulley (D1)
Fig.24. Attach the end of the cable to
the carabiner (60) and to chain (61),
position it on the end joined to the
support on the base, Fig.24.
Note: After a while you may notice
that steel cable slackens a little due to
the cable settling into position.
To remedy this just tension the steel
cable by changing the chain link (61).
30.- Fit the chain (62) onto the leg
accessory hook (41) Fig.24, to be able
to do the leg exercises.
31.- Attach the top casing (127) fitting
it over the upper body (1) so that it
slots onto the main body (5) Fig.25.
Fasten on using screws (97).
32.- Set the selector (70) as shown in
Fig.25 to be able to do the Butterfly
exercise.
REAR PROTECTION ASSEMBLY.-
32A.-Place the fixing points (133) in
the mesh (134) as shown in Fig.25A.
Then, position the fixing points (133)
on the main body (5), place the
screws (98), with washers (118) and
tighten, as shown in Fig.25A.
POSITIONING THE WEIGHT
SEECTOR ROD.-
33.-Insert the weight selector (44) rod
into the orifice of the weights required
for the exercise, as shown in Fig.26.
34.-When the rod notch has been fed
through the weight selector tube (39),
turn the selector rod anticlockwise, so
that the rod is held into place as
shown in Fig.27. Check that the
selector is firmly in position and that it
does not protrude from the weight
selector. To remove the rod, turn it
clockwise and pull.
For
optimum
conditions, the weights are already
marked with letters. By checking the
equivalence charts on the bottom of
the apparatus, you will be able to
check the exercised strength as the
meaning of each letter Fig.28 is
expressed in kilograms and pounds.
FOLDING THE SEAT.-
35.-To fold the seat, pull the safety rod
(71) and lift it in the direction of the
arrow as shown in Fig.29. The same
rod is used to put the seat back up.
Note: The seat can be put into two
different positions.
LEVELLING.-
36.-Once it has been firmly positioned
into place, check the base and ground
level of the machine. Levelling can be
improved by more or less swivelling
the adjustable feet (79) Fig.30.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO MODIFY
THE
SPECIFICATIONS
PRODUCTS WITHOUT PRIOR NOTICE
41
control
of
exercise
OF
ITS
Publicidad
