Working Advice - FAMOSTIL F-POWER 40-240 Manual De Instrucciones

03 After inserting the sheet, raise
clamping lever and return it to it's
original position. (PIC 4)
PIC 3
GRAIN TYPE
For the working of all wooden materials
Specification
For coarse-sanding,
e. g. of rough,
unplaned beams
and boards
For face sanding
and planing small
irregularities
For finish and fine
sanding of hard
woods
For the working of paint/enamel coats
or primers and fillers
Specification
For paint sanding
For sanding the first
painting layer
To finish before
vernishing
Grain 40-240
Thick
40,60
Medium 80, 120
Thin 180, 240
Grain 40-240
Thick 40,60
Medium 80, 120
Thin 180, 240
04
The abrasive sheet must be drawn as
tight as possible for efficient sanding,
as a loose sheet can slip on the work
surface.
PIC 4
SWITCHING ON AND OFF
01 To start the machine, tilt the On/Off
(Part 2 - PAG 7) toward the right to the
"I" position.
To switch off the machine, tilt the On/
02
Off toward the left to the "0" position.

WORKING ADVICE

01 Wait to the complete stop of the
machine before release it on any place.
02 This sander has been designed for
uniform weight distribution which
virtually eliminates the use of pressure.
Excessive pressure to the sander may
result in a non uniform sanding job and
can cause overheating and possible
damage to the tool.
03 It's usually better to work in strokes
that parallel the grain, using some
lateral motion so the main strokes are
overlapped as much as 75%.
25