Bulldog DCH Serie Manual De Instrucciones página 20

Mark warning
Extracts from the EC Directive:
1. EN 14492-1 Section 5.15.6 Wire Rope
Wire rope minimum break to be twice hoist rating
2. EN 14492-1 Section 5.7.2 Rope Drum
Rope drum mean diameter to be 10 times the diameter of the wire rope
3. EN 14492-1 Section 5.7.6 Rope Fastening onto the rope drum
Rope attachment to withstand 2.5 times the hoist rating
Rope must have at least two wraps winding before fixing point
4. EN 14492-1 Section 5.15.5 Brake
Hoist to hold full rated load
5. EN 14492-1 Section 5.15.2 Rated Capacity Limiters
The thermal overload cutout limit the driving power of the motor prevents hoist overloading
Standard compliance of EC Directives
The EC directive includes the following individual directives
Machinery Directive 2006/42/EC
It applies to independently functional machinery or the interlinking machines to form entire systems. The
complete machine and plant must always fulfill the directive.
Electromagnetic Compatibility Directive (EMC) 2004/108/EC
It applies to most electrical and electronic apparatus, that is, finished products and systems that include
electrical and electronic equipment to ensure that the electromagnetic disturbance generated by apparatus
does not exceed a level allowing radio and telecommunications equipment and other apparatus to operate as
intended, and that apparatus has an adequate level of intrinsic immunity to electromagnetic disturbance to
enable it to operate as intended.
Complies with SAE J706
Complies with ANSI B 30.5
FCC and Industry Canada (IC) warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / Tv technician for help.
20
CEQUENT
Legal Warnings
PERFORMANCE PRODUCTS, INC. •
™
F3839-00 REV C (4782) 08/15