Commissioning, Operation; Mechanical Mounting - WIKA 910.70 Manual De Instrucciones

5. Commissioning, operation

5. Commissioning, operation
Personnel: Skilled electrical personnel
Tools: Slotted screwdriver and tools for cable preparation
EN

5.1 Mechanical mounting

Required panel cutout: Ø 104 ±0.5 mm

Panel

Mounting bracket

Spacer part

Spacer disc

Mounting slot

1. Slide and align the indicator into the panel cutout from the front, so the front bezel
lies flat on the panel.
2. Assemble the mounting bracket with the 3 spacer rings as shown below.
With the screwdriver, set the position of the 3 spacer parts so that these, from the
control panel, are positioned approx. 3 mm in front of the mounting slots.
3. Place the spacer discs of the mounting bracket in the mounting slots.
4. Screw in the 3 spacer parts evenly using the slotted screwdriver, so that the indicator
is evenly and solidly mounted in the control panel.
10 WIKA operating instructions indicator for panel mounting, model 910.70



