Wall Mounting - Onkyo HT-R592 Manual De Instrucciones

■
Front
Status indicator
Off: Subwoofer in standby mode or
disconnected from power source
Blue: Subwoofer on
With the Auto Standby function, the
SKW-591 automatically turns on when
an input signal is detected in standby
mode. When there's no input signal for
a while, the SKW-591 automatically
SKW-591
enters standby mode.
■
Rear
(North American)
OUTPUT LEVEL control
This control is used to adjust the
volume of the subwoofer.
LINE INPUT
This RCA input should be
SKW-591
connected to the subwoofer pre
To AC outlet
out on your AV receiver with
supplied RCA cable.
(Asian) (Brazilian)
Note
• The Auto Standby function turns the subwoofer on when the
input signal exceeds a certain level. If the Auto Standby function
does not work reliably, try slightly increasing or decreasing the
subwoofer output level on your receiver.
All manuals and user guides at all-guides.com
Before Using the Home Theater
Speaker Package
Using the Rubber Stoppers for a More Stable
Platform
We recommend using the supplied rubber stoppers to
achieve the best possible sound from your speakers. The
rubber stoppers prevent the speakers from moving,
providing a more stable platform. Use rubber stoppers for
the center speaker.
Rubber stoppers
Using the Floor Pads for Subwoofer
If the subwoofer is placed on a hard floor (wood, vinyl,
tile, etc.) and playback is very loud, the subwoofer's feet
may damage the flooring. To prevent this, place the
supplied pads underneath the subwoofer's feet. The pads
also provide a stable base for the subwoofer.
En-2
Setting the Subwoofer Level
To set the level of the subwoofer, use the
OUTPUT LEVEL control. Set it so that bass
sounds are evenly balanced with the treble sounds
from the other speakers. Because our ears are less
sensitive to very low bass sounds, there's a temptation to
set the level of the subwoofer too high. As a rule of thumb,
set the subwoofer level to what you think is the optimal
level, and then back it off slightly.

Wall Mounting

To mount the front/surround/surround back speakers
vertically, use the keyhole slot shown to hang each speaker
Bottom of the
on a screw that's securely screwed into the wall.
SKC-591N/SKC-591
To mount the center speaker horizontally, use the two
keyhole slots shown to hang the speaker on two screws that
are securely screwed into the wall.
Pad
Tip
• If the center speaker is tilted, loosen the screw on the declined
side to move upward so that the speaker could be adjusted
vertically.
Keyhole slots for
wall mounting
SKF-591
SKR-590/SKB-590
Keyhole slots for wall mounting
SKC-591N/
SKC-591
7-7/8" (200 mm)