YATO YT-82834 Manual Original página 17

GB
parties (for example dispatch through courier service), then it is required to proceed in accordance with regulations for transport
of dangerous materials. Before shipment, contact an authorised person.
It is prohibited to transport damaged batteries. During transport the battery must be removed from the tool, and the exposed
contacts protected, e.g. with insulating tape. Protect the batteries so that they do not move inside the package during transport. It
is also required comply with the national regulations for transport of dangerous materials.
Charging the battery
Attention! Before charging you should disconnect the charger from the mains by unplugging the power supply plug from the mains.
In addition, you should clean the battery and its terminals of dirt and dust with a soft, dry cloth.
The battery has a built-in charge indicator. When you press the button, LEDs will light up (XI), the more LEDs will light up, the more
fully the battery pack is charged. If the button is pressed and the LEDs are off it means that the battery is discharged.
Disconnect the battery from the tool.
Push the battery in the charger socket (XI).
Plug the charger into a mains socket.
When the red LED lights up, it means the loading process.
When charging is complete, the red LED goes off , and green LED lights up, indicating a full charge of the battery.
Unplug the charger from the mains outlet.
Remove the battery from the charging station, by pressing the battery latch button.
Attention! If, when the charger is connected to the power supply, the green LED is on, this indicates a fully charged battery. In this
case, the charger does not start charging.
PRODUCT MAINTENANCE AND STORAGE
Note! Prior to any action described below disconnect the trimmer from the power source. Tools supplied from mains should be
unplugged, for battery driven tools, the battery should be disconnected.
After each use, check the condition of the tool paying particular attention to patency of ventilation slots.
Check the position of all tool components. Possibly tighten any loose bolted connection. Check the condition of blades. Clean
them with a brush and then preserve using lubricant agent in spray. The excess of lubricant agent to be wiped out. In case of any
damages or blade blunting, replace them in an authorised service point.
It is forbidden to use trimmer with damaged blades.
Take care that the blades are always lubricated. This will prevent corrosion which lowers the capacity of a tool, and may also
increase the risk of injuries. The clearance between blades should be between 0.2 and 0.4 mm counted at the location of screw
bonding two blades.
Blades are sharpened in the factory in order to attain the optimum capacity of operation, but they become blunt due to work. Prior
to each job check the condition of blades. If the upper edge of blade becomes round or rounding of lower part of the blade disap-
pears, you need to have blades sharpened (XII). Sharpening should be carried out in manufacturer's authorised service point.
Before storing the trimmer for a longer period of time, spray the blades with preserving fl uid or distribute it along blades using a
brush. The excess of preserving fl uid remove immediately before the work. Such maintenance will reduce the risk of blade cor-
rosion.
The tool housing should be cleaned using a soft dry cloth. The housing should be cleaned from wooden residues, oil, lubricant and
other dirt. The device to be stored in dry, contained room, disconnected from mains.
The device should be stored in a shaded, dry places equipped with proper ventilation preventing condensation of steam. The
place should be inaccessible for third parties, children in particular. When storing, the guide rail and chain should always be
protected by cover.
O R I G I N A L I N S T R U C T I O N S
17