Carton Contents; Charging Procedure - SNOWJOE SUNJOE SJ-APS-1G Manual Del Operador

Unpacking

Carton Contents

• Cordless chemical sprayer with hose
• Spray wand assembly
• Battery charger
• Shoulder strap
• Manual with registration card
1. Carefully remove the cordless chemical sprayer and check
to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use your new cordless
chemical sprayer. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils,
or small parts. These items can be swallowed and pose a
suffocation risk!

Charging Procedure

The battery charger supplied matches the lithium-ion battery
installed in the tool. Do not use other battery chargers.
The lithium-ion battery is protected against deep discharging.
When the battery is empty, a protective circuit will
automatically switch OFF the machine.
Charging the Battery
1. Plug the charger into an appropriate AC power outlet.
Remove the rubber socket cover and connect the charger
plug into the charging socket to start charging (Fig. 1).
Power button
Fig. 1
2. The light on the power button will shine red when it is
charging and green once it is complete. The charger turns
off automatically once the battery is fully charged.
The green light will turn off after 5 hours (Fig. 1).
customer service center at
®
Rubber cover
Charging socket
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery
3. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become
fully discharged as this will cause irreversible damage to
the battery.
Assembly
1. Insert the water outlet end of the trigger gun into the
end of spray wand as show (Fig. 2), and turn counter
clockwise to tighten.
Fig. 2
Trigger gun
2. Insert the trigger gun inlet end into the trigger gun
connection on the hose and turn to tighten securely
(Fig. 3). The sprayer is ready to use.
Fig. 3
Hose
Adding the Shoulder Strap
1. Slide each end of the shoulder strap into each strap bar
on the ends of the unit. Then, securely weave the ends of
the straps into the strap buckle (Fig. 4).
6
Spray wand
Trigger gun
Trigger gun connection