Wiring - Craftmade LOU52 Guia De Instalacion

6. Wiring

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
When downrod is secured in place on the
hanging bracket, WIRE THE RECEIVER with wire
connectors provided as shown at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into
hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch. Wire the WALL CONTROL with wire
connectors provided as shown at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control. Factory
setting is pre-set and not recommended for use. Write
down number sequence for use in Section 10.
Note: Since this fan comes with a halogen bulb, the
dimmer switch (labeled D and X) has been pre-set to
the "ON" position (D). If you do not wish to have
dimming capability, please move the switch to the
"OFF" position (X).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall control.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
(wiring for receiver)
(wiring for wall control)
radio
radio or television
page 6
white supply wire
black supply wire
blue
black
white
from fan
from receiver
white
black
blue
receiver
outlet box
green/ green/ green/
bare bare
bare
ground ground ground
green
black (OUT to fan) black (OUT to fan)
black black
black black
(TO POWER supply) (TO POWER supply)
black black
(AC IN from (AC IN from
breaker box) breaker box)
ground (green
or bare)
ground (green
or bare)
black
from ceiling
from receiver
black
AC IN L
white
AC IN N
*
antenna
wall
control
plate
code
switches
dimmer
switch