Uline H-8513 Manual Del Usuario página 2

2. Use backrest and backrest mounting kit to assemble.
Align plastic holder post and steel plate to backrest.
Use Allen wrench to tighten with supplied screws.
Place cover over assembly. (See Figure 2)
Figure 2
Plastic Cover
Screw
Post and
Optional Cover
3. Align armrest mounting bracket with holes on bottom
of seat and use four armrest screws to attach. Insert
armrest into mounting bracket and use armrest knob
with washers to secure. Repeat on opposite side.
(See Figures 3-4)
NOTE: Install armrest mounting brackets with
arrow pointed away from center of seat.
NOTE: Use Allen wrench to tighten screws.
Figure 3
PAGE 2 OF 9
ASSEMBLY CONTINUED
Steel Plate
Plastic Holder
Figure 4
4. Align mechanism with holes on bottom of seat. Use
four seat screws to attach. (See Figure 5)
Figure 5
5. Place plastic cover over socket on mechanism and
slide assembled backrest post through plastic cover
and into socket. Insert plastic stopper and tighten
knob to secure. (See Figure 6)
Figure 6
6. Slowly lower stool assembly onto the gas lift. Press
down on seat to secure.
Socket
0621 IH-8513