Preparing The Filter System; Operation - Steinbach Classic 310 Manual Original

1. Screw a hose adapter
onto the prefilter cover
2. Make sure that water from the supply
or drain line does not flow into the
pool.
3. Push the hose end onto the hose
adapter and use the hose clamps to fix
the hose in place.
The suction line is connected.
Connecting the backwash line
A rubber stopper is inserted in the "WASTE" connection at the factory. You
can leave this stopper in, if you are not using the backwash line (e.g. when
using filter balls as filter medium), to protect the device from dirt and insects
entering the system.
1. Pull the rubber stopper out of the "WASTE" connection in the valve head
2. Connect one end of the hose to the "WASTE" connection.
3. Guide the second hose end towards the channel connection.
The backwash line

Preparing the filter system

1. Press and hold down the valve lever
2. Set the valve lever to the "BACKWASH" position and release it.
3. Allow the filter vessel
backwash line
4. Check the filter system and the connections for leaks.
In the case of leaks, wrap extra Teflon tape
5. Backwash the system (see section "Backwashing").

Operation

A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").
56
clockwise
21
.
4
is connected.
30
to fill with water until the water runs out of the "WASTE"
2
.
30
Risk of injury!
18
21
on the valve head
31
around the affected connections.
23
CAUTION!
.
1
.
1
4