Publicidad
Idiomas disponibles
Idiomas disponibles
I.
Pushchair parts
II.
Instructions for installation and use
Unfolding the pushchair frame
•
Pull the front part of the frame responsible for holding the front wheels of the pushchair in
place, until you hear a "click" (figures 1 and 2).
•
Pull the pushchair handle upwards. The "click" sound means that the handle has been locked
in a secure position (figure 3).
Installation and removal of the front swivel wheels
•
Slide the front wheels into the holes on the front of the frame. A characteristic "click" indicates
their correct installation (figure 4). To remove the front wheels, press the metal button above
the wheel and pull the wheel out (figure 5).
•
The front wheels can be locked so that they only move in one axis (front to rear), using the
slider located above the wheel, on the inside of the frame. Moving the lock down activates it. To
unlock the wheels again, move the slider upwards (figure 6).
Installation and removal of the rear wheels
•
Slide the rear wheels into the holes in the back of the frame. A characteristic "click" indicates
their correct installation (figure 7). To remove the wheels, press the button on the underside of
the frame and pull them out (figure 8).
Caution! Make sure all the wheels are correctly fitted before using the pushchair.
Installing and removing the seat/carrycot
•
Slide the two adapters on the sides of the seat/carrycot into the guides on the frame of the
pushchair. A clicking sound indicates that the seat is correctly positioned (figure 9).
•
Unfold the seat/carrycot by tilting the folded part towards the front of the pushchair
(figure 10).
•
Pull the handle on the outside of the upper part of the seat/carrycot and pull it as far as
possible upwards (figure 11, 12).
•
To remove the seat/carrycot from the frame, press both buttons under the adaptors
simultaneously and lift it up (figure 13).
Installation of the safety bar
•
To install the safety bar, slide it into the holes located on both sides of the seat/carrycot. The
bar is correctly mounted when you hear a characteristic "click" during installation (figure 14).
•
To remove the bar, slide down the slider located near its attachment, on the inside, and pull
the bar off at the same time. Do the same on both sides of the bar (figure 15).
WARNING! The safety bar is optional and does not exempt you from the requirement to use a
5-point seat belt.
20
no.
A
B
C
D
E
F
G
H
I
Extra inserts for the carrycot
J
element
Pushchair frame
Seat
Safety bar
Front wheels
Rear wheels
Leg cover
Rain cover
Mosquito net
Canopy
quantity
1
1
1
2
2
1
1
1
4
1
Publicidad
