Electrical Connection - ROBLIN MAESTRO Manual De Uso

EN
The use of hard wood decorative bor-
Z X
ders around the worktop behind the
appliance is allowed, in this case the
minimum distance remains as indicat-
ed on the installation illustrations.
The minimum distance between the
Z X
built-in appliance and rear wall is
indicated at the illustration for the
installation of the built-in appliance
(150 mm for the side wall, 40 mm for
the rear and 500 mm minimum for
any cabinets above it).
To prevent leakage of liquid between
Z X
the edge of the hob and the counter-
top, place the adhesive seal provided
along the entire outer edge of the
hob before assembly.

ELECTRICAL CONNECTION

The wire connection has to be done
Z X
by specialized technician.
This appliance has a Type "Y" attach-
Z X
ment and requires at least a power
supply cord Type H05VV-F.
MONO-PHASE, BI-PHASE and
THREE-PHASE connection: min.
section of the conductors: 2,5 mm².
External diameter of the supply cord:
min. 7 mm - max. 15 mm.
Connection terminals are revealed
Z X
when the connection box cover is
removed.
Make sure the characteristics of the
Z X
household electrical system (voltage,
26
Proper use
The extractor appliance has been
Z X
designed exclusively for domestic
use to eliminate kitchen smells.
Never use the appliance for purposes
Z X
other than for which it has been designed.
Deep fat fryers must be continuously
Z X
monitored during use: overheated oil
can burst.
Do not operate the appliance with an
Z X
external time switch or a separate
remote control system.
The appliance shall not be installed
Z X
behind a decorative door in order to
avoid overheating.
To avoid damaging the appliance do
Z X
not climb onto the appliance.
To avoid damaging the silicon grouting, do
Z X
not put hot cookware on the frame.
Do not cut or prepare food on the
Z X
surface or drop hard objects onto it. Do
not drag cookware across the surface.
maximum power and current) are com-
patible with those of the appliance.
Connect the appliance like shown in
Z X
the diagram (in accordance with the
mains voltage and country standard
reference).
We suggest to use power supply
Z X
cord 5 x 2.5 mm² H05V2V2-F. In
case of use of power supply cord
5 x 2,5 mm² H05V2V2-F, below
instructions have to be followed: for
three-phase connection separate the
2 wires and remove the blue sheaths
on grey wires.