Descargar Imprimir esta página

Sinbo SHD 2694 Manual De Instrucciones página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
Care and maintenance: This appliance requires little maintenance and contains no user
serviceable parts. Do not try to fix it yourself. Refer it to qualified service personnel if
servicing is needed.
To clean: Unplug curling iron and allow it to cool. Iron must be cleaned only when cold.
Use a soft, slightly damp cloth to wipe the handle. Do not allow water or any other liquid
to go into handle of the iron.
To Store: Unplug appliance and let it cool, store in its box or in dry place. Store the cool
loosely coiled. Never wrap the cord around unit. Do not put any stress on cord where it
enters the handle as it could cause cord to fray and possible break. Never hang unit up
by the power cord.
Special Attention: Your new iron is designed with a protective coating around the heating
coils. When plugged in and operating for the first time, there may be a little momentary
smoking while this coating is initially heated. This represents no danger to the user and
does not indicate a defect in your curling iron. When using for the first time, allow it to
continue running until the smoke dissipates. This should last only about 30 seconds.
1. Do not leave appliance unattended while it is operating or is plugged in.
2. Close supervision is necessary when this appliance is used by, on, or near children or
invalids.
3. Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.
4. Never operate this appliance if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged into water. Take appliance to nearest service
facility for examination and repair or mechanical adjustment.
5. Keep the cord away from hot or heated surfaces.
6. Never use while drowsy.
7. Never drop or insert any object into any opening as this may cause an electrical hazard.
8. Do not use outdoors or operate where aerosol (spray) products are being used. Do not
operate where oxygen is being administered.
9. Unit as hot when in use. To avoid burn hazard, do not let heated surface touch bare
skin.
10. Do not place the heated unit directly.
- 8 -

Publicidad

loading