3Com AP9152 Manual Del Usuario página 106

This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF Requirements
RF exposure Hazard Warning
This device generates and radiates radio-frequency energy. In order to comply with
FCC radio-frequency exposure guidelines for an uncontrolled environment, this
equipment must be installed and operated while maintaining a minimum body to
antenna distance of 20 cm (approximately 8 in.)
RF Frequency Requirements
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located or
operating in conjunction with any other unauthorized antenna or transmitter.
This device is for indoor use only when using channels in the 5.15 to 5.25 GHz ,5.47
to 5.6GHz or 5.65 to 5.725GHz frequency range.High power radars are allocated as
primary users of the 5.25 to 5.35 GHz and5.47 to 5.6 GHz and 5.65 to 5.725 GHz.
These radar stations can cause interference with and/or damage this device.
This device will not operate on channels which overlap the 5600 - 5650 MHz band.
Antennas
Only use the supplied antenna. Unauthorized antennas, modifications or change to the
antennas could violate FCC regulations and void the user's authority to operate the
equipment.
All manuals and user guides at all-guides.com
103