Publicidad
Idiomas disponibles
Idiomas disponibles
PAGE 2 OF 6
ASSEMBLY CONTINUED
2. Connect remaining crossbars to the same A-frame
Figure 2
by sliding ends over the knobs on the A-frame,
making sure the holes match up. (See Figure 2)
3. Secure each crossbar with a small screw on both
sides.
4. Connect second A-frame to the top crossbar and all
Figure 3
other crossbars using the same methods as steps 1-3.
(See Figure 3)
5. Insert casters into pre-drilled holes on the bottom of
the A-frame. The two casters with brakes should be
placed on the same side of the unit, one on each
A-frame. (See Figure 4)
6. Insert the shoe racks by sliding one protruding end
Figure 4
into the slot in the inside of the A-frame, then repeat
with the other end. (See Figure 5)
7.
Repeat for all remaining shoe racks.
8. To install the sign holder, place the pointed end into
the center hole on the top crossbar. To change the
direction it faces, remove, rotate 90 degrees and
reinsert the sign. (See Figure 6)
Figure 5
1-800-295-5510
uline.com
NOTE: It may be helpful to lay the first A-frame
on the ground and attach all of the crossbars
vertically, in order to more easily attach the
second A-frame.
NOTE: It may be helpful to use a needle nose
pliers to screw the caster stem into the A-frame.
Figure 6
0421 IH-4381
Publicidad
