1.
Attach Caster Wheels (#9 & #10) to Caster Beam Assembly.
Slide a Caster Wheel
with
Assembly (#7) and secure it with a Push Nut (#11) as shown
in
figure 1
. Gently tap the Push Nut (#11) with a hammer
to secure it in place.
On the other end of the Caster Beam
attach a Caster Wheel
have one caster wheel with lock and a caster wheel without
lock for each Caster Beam Assembly.
Repeat this step to attach the Casters to the second Caster
Beam Assembly.
11
29
7
31
31
10
34
Caster
with
Lock
Note: Linkages & Strut
tubes must be turned as
shown or table will not
operate correctly.
Figure 2
28
Lock (#10) through Caster Beam
without
Lock (#9). Make sure you
Note: Support Plate (#43)
must be on inside of Caster
Beam (#7) as shown.
43
Caster
without
9
Lock
31
31
9
Caster
without
Lock
16
39
7
13
36
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
2.
Attach Wood Bottom Board (#15) to Caster Beam
Assemblies (#7) as shown in
Beams as shown and attach board with four Hex
Head Bolts (#29), eight Flat Washers (#31) and
four Locknuts (#34) Tighten nuts securely.
29
31
31
31
31
15
34
3.
Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies
(#7) as shown in
figure 2
a)
Loosen
Bolts (
#13) and Nuts (#28) so that Strut Tube (#17) can fit
between Inner Support Plate (#43) and Caster Beam (#7) as shown in the
Top View
and
figure 2
b)
Slide one Hex Bolt (#27) through inner
by one Plastic Washer (#39), Strut Tube (#17), one Plastic Washer (#39),
pass through Caster Beam (#7), one Spacer (#36), one Linkage (#16),
and Lock Nut (#28).
c)
Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d)
Tighten
Bolts
(#13) and Nuts (#28) securely.
e)
Tighten Nuts (#28) on Bolts (#27) securely.
NOTE:
Tighten nuts so that end of Bolt (#27) in even with the edge of nut.
17
43
27
3
7
Figure 1
Caster
with
10
Lock
.
.
Support Plate (#43)
27
7
39
13
7
36
figure 1
. Turn Caster
, followed
Top View
17
43
(Inner Plate)
28
12
16
28