Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ALIGN BOTTOM HANGERS FOR MOUNTING
1.
Determine board location. Measure bottom edge
of board from the floor. Mark the corner location for
bottom hangers with pencil (A). (See Figure 1)
2. Align bottom hangers with marked line three inches
from each corner of board. Mark screw hole
location at top of slot by arrows (B). (See Figure 1)
3. Drill 1/4" hole in wall in the marked location for each
bottom hanger (C). (See Figure 1)
4. Tap drywall anchors into pre-drilled holes. Drive No.
10 screw through top of slotted hole of hanger, into
drywall anchor. Tighten firmly (D). (See Figure 1)
Figure 1
A
PAGE 2 OF 9
MOUNTING
D
C
B
CHECK BULLETIN BOARD IS LEVEL
5. Place board onto bottom hangers (E). Make sure
frame is securely engaged (F). Check that board is
level. (See Figure 2)
NOTE: To reposition hanger, mark corrected hole
location along side of hanger. Use a new anchor.
Figure 2
E
F
0521 IH-7809
Publicidad
Tabla de contenido
